DIMMER PROFESSIONAL MULTI-LED 2500W
DM-2500W

Dimmer DM - 2500 was designed to cover the needs of professional stores on basic sections oflighting and ventilation. It is an absolutely safe to use and reliable product as it isconstructed with special integrated circuits and tough plastic so it can function under adverse conditions.
Control : Dimmer DM - 2500 is controlled by a a rotary potentiometer which controls the current and the power consumption to the desired level from 1% to 100%. The is also an embedded switch in the potentiometer (press switch) to activate and deactivate the device.
Lower level setting : As it is mentioned at the technical characteristics topic, DM - 2500 has the ability to adjust the minimum level of output power so that it can be used to control electric single phase motors, in which it is essential to prevent the dimmer from delivering less power than it is necessary to turn the motor on. This specific procedure is succeeded by adjusting a potentiometer which is found inside the product.

1st Step: Set the main potentiometer at lowest setting.
2nd Step: Meanwhile, remove the mask of the device (DM - 2500) and then set the potentiometer which is inside the dimmer (ADJ) to the lowest allowed desired limit.
3rd Step: Repeat the same procedure in order to reset the lowest limit.

Note :
a) Highest setting of lowest limit is 50%.
b) After the procedure’s completion (lowest limit setting) dimmer forbids us to reduce the power of electric load more than the presetting. However it allows us to increase it up to 100%.

Technical Specifications

DIMMER: Electronic - digital
OPERATING VOLTAGE: 180 - 230 V - AC
OPERATING FREQUENCY: 50Hz
MAXIMUM OUTPUT POWER: 2500 Watt


CONTROL LOAD:

  • RESISTIVE & HALOGEN
  • INDUCTIVE TRANSFORMERS
  • ELECTRONIC TRANSFORMERS
  • LED
  • ELECTRIC SINGLE - PHASE MOTORS:
  1. Universal
  2. Asynchronous with torque strongly depended from motor speed (centrifugal pumps, fans, ventilations).

ENVIRONMENTTEMPERATURE:-20°C until +50°C
FUSE: 15 A / 230VAC (for short-circuit protection)
WIRE SIZE: From 0.5 mm to 3.5 mm
FIXING: Surface-mounting

EUROPEAN COMMUNITY DIRECTIVES:


The product complies with directives:
Low Voltage Directive: 2014/55/EU
EMC Directive: 2014/30/EU
EN 60669-1
EN 60669-2-1

Draft of Electrical Installation

3D Preview

Watch the three-dimensional representation of the product by long pressing click